Performance and Emission Characteristics of a V.C.R C.I Engine using Chicken Waste Based Bio-Diesel with Blended Fuels IJTSRD
This project deals with the preparation of Oil (extraction of oil) from the chicken waste which is obtained from tri-glycerides through the transesterification process to find Performance and emission characteristics of V.C.R diesel engine with ratio 18:1 fuelled with rendered chicken oil with five different blends at speed 1500rpm. The chicken oil is prepared from […]
Experimental Investigations and Computational Analysis on Subsonic Wind Tunnel IJTSRD
This paper disclose the entire approach to design an open circuit subsonic wind tunnel which will be used to consider the wind impact on the airfoil. The current rules and discoveries of the past research works were sought after for plan figuring of different segments of the wind tunnel. Wind speed of 26 m s […]
Design and Analysis of Crankshaft for Internal Combustion Engine IJTSRD
In this project design and analysis of the crankshaft for the combustion engine. These components have a large volume component with complex geometry and need huge investment. These will be converts reciprocating or linear motion of the piston into a rotary motion. In this project the product is modeled in a 3D model with all […]
Additive Manufacturing of Leaf Spring IJTSRD
Additive manufacturing AM , colloquially known as 3 D printing, refers to set of emerging technological that offer unique capabilities However, this design freedom is countered by build envelope and production rate constraints characteristic of most commercially available AM equipment. This paper presents an approach for architecting complex additively manufactured products using the design structure […]
Optimization of EDM Process Parameters using Response Surface Methodology for AISI D3 Steel IJTSRD
The present work demonstrates the optimization process of material removal rate MRR of electrical discharge machining EDM by RSM Response Surface Methodology . The work piece material was EN31 tool steel. The pulse on time, pulse off time, pulse current and voltage were the control parameters of EDM. RSM method was used to design the […]